Currently unavailable
This product is not available at the moment. Check back later or explore other options below.
This guide is for homeowners and installers looking for discreet, high-quality audio solutions that blend seamlessly into ceilings or walls. The Loops 6.5" 2-Way Low Profile Ceiling Speakers offer versatile 100V and 8 Ohm compatibility, easy installation, and a paintable grille for a clean aesthetic. While they provide excellent sound for their size, users should be aware of the wattage limitations in 100V systems to prevent amplifier strain.
| Colour | Multicolor |
|---|---|
| Brand | Loops |
No, these speakers are designed for indoor use only and are not weatherproof.
An 8 Ohm system uses standard speaker wire and impedance matching. A 100V system uses a transformer to boost voltage, allowing multiple speakers to be run in parallel from a single amplifier, typically for distributed audio over longer distances with consistent volume.
Select the wattage tapping that best suits the desired volume level for that specific speaker. Lower tappings provide less volume and draw less power, while higher tappings provide more volume and draw more power. Ensure the sum of all tappings does not exceed 80% of the amplifier’s power rating.
Yes, as long as they are all connected to a 100V amplifier, you can mix different brands and models, but always ensure the total wattage does not exceed the amplifier's capacity.
For an 8 Ohm setup, the speakers are rated for 50W RMS / 100W Max. It is generally recommended to use an amplifier that provides between 50W and 100W per channel for optimal performance.
The mounting depth required is 99mm.
The required cut-out diameter is 202mm.
Check all wire connections for tightness and correct polarity (+/-). Ensure the amplifier is powered on and set to the correct input. For 100V systems, verify the wattage tapping is correctly set and the total system wattage is within the amplifier's limits.
Ensure the speaker wire is not damaged and connections are secure. Check that the speaker is not being overdriven (too high volume for the amplifier's output or the speaker's rating). For 100V systems, confirm the wattage tapping is appropriate for the desired volume.
Verify the selected wattage tapping on that speaker is the same as or higher than other speakers in the same zone. Ensure the total wattage load on the amplifier is not exceeded.
Check for loose wire connections at both the speaker and amplifier terminals. Inspect speaker wire for any signs of damage or fraying. Ensure the amplifier is functioning correctly.
Setup:
Compatibility:
Care:
