Osmo Stone And Terracotta Oil Exterior - Clear Satin 750ml
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This Osmo Stone and Terracotta Oil is designed for homeowners and professionals looking to protect and enhance exterior stone and terracotta surfaces. Its key benefit is providing robust protection against dirt, abrasion, and water while maintaining a breathable, microporous finish that prevents cracking and peeling. A potential caveat is the drying time, which requires planning for clear weather.
All features
| Brand | Osmo |
|---|
Extended Product Information
FAQs
How many coats of Osmo Stone and Terracotta Oil should I apply?
We recommend applying two thin coats for optimal protection and water repellency. Allow 8-10 hours drying time between coats.
Can this oil be used on interior stone surfaces?
While designed for exterior use, it can be used indoors on unglazed stone or terracotta. Ensure excellent ventilation during application and drying.
What is the coverage rate?
The coverage is approximately 32m² per litre for one coat on smooth, dense surfaces. Porous surfaces will consume more product.
How long does the protection last?
The longevity of the protection depends on the environmental conditions and wear. Typically, reapplication may be needed every few years.
Can I apply this oil over existing sealers?
It's best to test on an inconspicuous area first. Remove any old, flaking coatings. The oil is most effective on raw, unglazed surfaces.
What is the drying time?
The drying time is typically 8-10 hours under normal conditions (around 20°C and 50% relative humidity). Cooler temperatures or higher humidity will extend drying time.
Troubleshooting
Uneven finish or patchy appearance
Ensure the oil was applied thinly and evenly. Wipe away any excess oil that has not penetrated the surface within 10-20 minutes of application. Ensure consistent application technique.
Surface remains tacky after 24 hours
This can happen if applied too thickly or in very humid/cold conditions. Try to gently wipe away excess uncured oil with a cloth dampened with the product. Ensure adequate ventilation.
Water beading is not effective
The surface may require a second coat, or the original coat may be wearing thin. Reapply one thin coat according to instructions.
Pros and Cons
Pros
- Provides excellent water repellency.
- Protects against dirt and abrasion effectively.
- Microporous and breathable finish prevents surface damage.
- Suitable for various natural stone and terracotta types.
- Helps maintain the natural appearance of the treated surface.
Cons
- Requires a dry period for application and drying (8-10 hours).
- May alter the natural color slightly depending on the stone type.
- Application on very porous surfaces might require more product.
Setup, Compatibility & Care
Preparation: Ensure the surface is clean, dry, and free from dust, grease, or old coatings. For previously treated surfaces, test for compatibility. Allow damp surfaces to dry completely before application.
Compatibility: Suitable for unglazed terracotta, granite, limestone, slate, and other natural stone. Not recommended for polished or highly sealed surfaces.
Application: Apply thinly and evenly with a brush or roller. For best results, apply two coats. Allow 8-10 hours drying time between coats in well-ventilated conditions and at a temperature of at least 15°C. Ensure adequate ventilation during application and drying.
Care: Clean treated surfaces with water and mild soap. Avoid abrasive cleaners which can damage the protective layer. Reapplication may be necessary every few years depending on exposure and wear.