Tetrosyl Brushable Seam Sealer - TETBSS001PK6
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Tetrosyl Brushable Seam Sealer is designed for automotive professionals and DIY enthusiasts seeking to protect overlap seams from dust and water. Its key benefit is providing a permanently flexible, non-slumping seal ideal for various joints. A caveat to note is the specific drying time and the need for proper surface preparation.
All features
| Model Part Number | TETBSS001PK6 |
|---|---|
| Brand | Tetrosyl |
Extended Product Information
FAQs
What surfaces can this seam sealer be used on?
It is designed for use on vehicle body seams, particularly overlap areas. Always ensure the surface is prepared correctly.
How long does it take to dry?
The sealer dries to the touch in approximately 2 hours at 20°C. Full curing time before painting may vary.
Can I apply more than two coats?
It is recommended to apply no more than two coats for optimal performance and adhesion.
What type of brush should I use?
A nylon bristle brush is recommended for application.
Can I use this sealer in cold weather?
Drying times are significantly affected by temperature. It is best applied in moderate conditions (around 20°C) for the specified drying time. Store in a cool, dry place.
What is the shelf life of the product?
Refer to the product packaging for specific shelf-life information. Store in a cool, dry place.
Is this sealer suitable for exterior use?
Yes, it is designed to protect against dust and water penetration, making it suitable for exterior automotive seams.
Troubleshooting
Sealer not adhering properly
Ensure the surface was thoroughly degreased with Tetrosyl Compliant Panel Wipe and is completely dry before application.
Sealer sagging or running
Apply thinner coats and ensure the surface is not excessively angled. The product is designed to be non-slumping, but extreme angles can still pose a challenge.
Difficulty brushing a smooth coat
Use a high-quality nylon bristle brush. Ensure the sealer is at room temperature for easier application.
Paint not adhering to cured sealer
Verify that the sealer is fully cured according to the drying time recommendations. Ensure the correct type of paint system (nitro-cellulose, acrylic, or synthetic) is being used.
Pros and Cons
Pros
- Provides excellent protection against environmental ingress.
- Stays flexible, preventing cracks in seams.
- Suitable for application on both vertical and horizontal surfaces.
- Can be painted over for a finished look.
- Dries to touch in 2 hours under ideal conditions.
Cons
- Requires specific surface preparation (degreasing).
- Can only be overcoated once fully cured.
- Drying time is dependent on temperature (2 hours at 20°C).
- Only two coats are recommended.
- Requires a specific brush type for application.
Setup, Compatibility & Care
Preparation: Before application, ensure the surface to be treated is clean, dry, and free from contaminants. Thoroughly degrease the area using Tetrosyl Compliant Panel Wipe.
Application: Apply a smooth, even coat using a nylon bristle brush. Always brush in the same direction to ensure a consistent finish. Avoid applying more than two coats. The product typically dries to the touch in 2 hours at 20°C.
Compatibility: Once fully cured, Tetrosyl Brushable Seam Sealer can be overcoated with nitro-cellulose, acrylic, or synthetic refinishing paint systems.
Care: Store the product in a cool, dry place away from direct sunlight and extreme temperatures.