This FloPlast square 92.5° offset bend connects square downpipes around projections such as sills or eaves. Used to maintain a continuous flow in vertical rainwater systems, it fits standard 65mm square downpipes in domestic drainage installations. 92.5 Bends are used in a downpipe system to change the plane of the bend from vertical to horizontal or vice versa. They are often used instead of offset bends when the soffit is particularly wide - this enables the pipe to run neatly below the soffit rather than dropping down diagonally back to the wall as it would with a normal swan neck setup. The angle of the bend is 92.5 degrees rather than 90 degrees to encourage a slight fall, enabling rainwater to run away rather than sit in the pipe.