U-POL ISOPON P40 Body Filler For Holes - 100ml
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
This guide is for anyone using U-POL ISOPON P40 Body Filler for Holes. It helps you understand how to effectively repair rust holes up to 75mm wide, providing a tough and durable finish. Keep in mind that proper surface preparation is key for optimal results.
All features
| Model Part Number | P40/100 |
|---|---|
| Brand | U-POL |
Extended Product Information
FAQs
What is the shelf life of the filler?
The shelf life is typically indicated on the product packaging. Store in a cool, dry place to maximize shelf life.
Can I use this filler on plastic parts?
No, this filler is specifically designed for metal bodywork. Use appropriate fillers designed for plastics.
How long does it take for the filler to cure?
Curing time depends on temperature and humidity, but it is usually within 20-30 minutes.
Do I need to use a primer after applying the filler?
Yes, always use a suitable primer after sanding the filler to provide a base for the topcoat.
Can I use this filler on exhaust systems?
No, this filler is not designed for high-temperature applications. It is for bodywork only.
How do I store the remaining filler?
Close the tube tightly after use. Store in a cool, dry place away from direct sunlight.
Troubleshooting
Filler not hardening
Ensure correct mixing ratio of filler and hardener. Check the expiry date and storage conditions of the filler and hardener.
Filler cracking after application
Ensure proper surface preparation. Apply filler in thin layers, allowing each layer to cure before applying the next. Avoid applying too much filler at once.
Difficulty sanding the filler
Allow the filler to cure completely before sanding. Use progressively finer grades of sandpaper.
Pros and Cons
Pros
- Durable and long-lasting repairs.
- Easy to sand, allowing for a smooth finish.
- Can bridge holes up to 75mm in diameter.
- Comes with an applicator for ease of use.
- Easy to mix with clear instructions.
Cons
- Requires additional materials like aluminium mesh for larger holes.
- May require multiple applications for deep holes.
- Requires proper surface preparation for optimal adhesion.
- Mixing ratio must be followed for best results.
- Limited to rust hole repairs up to 75mm.
Setup, Compatibility & Care
- Preparation: Clean the area to be repaired with a suitable cleaning agent to remove any grease, wax, or loose particles.
- Mixing: Use the graduated rule on the carton to mix the filler with the hardener according to the instructions. The mixing ratio is provided in cm.
- Application: Apply the mixed filler to the damaged area using the applicator provided. If the hole is larger than 75mm, use aluminium mesh to support the filler.
- Curing: Allow the filler to cure completely according to the manufacturer's instructions. Curing time will vary depending on temperature.
- Sanding: Once cured, sand the filler smooth using progressively finer grades of sandpaper.
- Compatibility: Compatible with most automotive paints and primers. Always test compatibility on a small area first.
- Care: Store the product in a cool, dry place away from direct sunlight. Ensure the container is tightly sealed when not in use.