Integral LED Evofire Downlight - Satin Nickel
Not Available
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later or explore other options below.
Product Information
Full details
The Integral LED Evofire Downlight is designed for discerning users in commercial and high-end residential spaces seeking discreet, reliable, and safe lighting solutions. Its key benefit lies in its advanced heat dissipation and micro-bezel design, ensuring longevity and seamless integration. A potential caveat for some users might be its specialized installation requirements compared to standard downlights.
All features
| Colour | Silver |
|---|---|
| Model Part Number | ILDLFR60D105 |
| Brand | Integral LED |
Extended Product Information
FAQs
What is the IP rating of this downlight?
The Integral LED Evofire Downlight has an IP65 rating, meaning it is protected against dust and low-pressure water jets, making it suitable for bathrooms and kitchens.
What are the dimensions and required cut-out size?
The downlight dimensions are 72mm x 72mm x 49mm. The required cut-out diameter is 60.00mm.
Is this downlight fire-rated?
Yes, it is fire-rated and certified for 30, 60, and 90 minutes on solid timber joists.
How does the heat dissipation work?
The downlight features a unique open structure design that allows for improved airflow and heat dissipation, causing lamps to run up to 10°C cooler compared to traditional canned fixtures.
Can I install this in a bathroom?
Yes, due to its IP65 rating, it is safe for use in bathrooms and kitchens. Always ensure installation complies with local electrical regulations.
What is the benefit of the micro bezel?
The micro bezel is significantly smaller (40% less than standard bezels) for a more discreet and seamless integration into the ceiling, offering a cleaner aesthetic.
Does it come with a light source?
This product is a fitting only and does not include a separate lamp. Please ensure you select a compatible LED lamp.
Troubleshooting
Downlight does not illuminate
Check that the power supply is on and that connections to the loop-in/loop-out terminal block are secure. Verify the circuit breaker is not tripped.
Flickering light
Ensure the wiring connections are tight and that the downlight is compatible with the dimmer switch (if used). Some LED drivers may require specific dimmer types.
Reduced lifespan or overheating
Confirm that the cut-out diameter is correct (60.00mm) and that there is adequate airflow around the fitting as per installation guidelines. Ensure the lamp is running cooler due to the design, but any excessive heat indicates a potential issue.
Pros and Cons
Pros
- Discreet, minimalist aesthetic with micro bezel
- Enhanced safety with fire resistance and IP65 rating
- Improved lamp longevity due to superior heat dissipation
- Streamlined installation process with loop-in/loop-out terminals
- Suitable for moisture-prone areas like bathrooms and kitchens
Cons
- Requires a specific cut-out diameter of 60.00mm
- Installation may require professional knowledge due to fire ratings
- Open structure, while beneficial for heat, may allow dust ingress if not properly sealed in certain environments (though IP65 mitigates this for water)
- Limited to specific finishes
Setup, Compatibility & Care
Setup:
- Ensure power to the circuit is switched off at the mains.
- Cut a hole in the ceiling with the specified 60.00mm diameter.
- Utilize the loop-in/loop-out terminal block for connecting the power supply wires.
- Insert the downlight into the ceiling cut-out, allowing the micro bezel to sit flush.
- Re-energize the circuit.
Compatibility:
- Designed for solid timber joists with certified fire resistance (30, 60, 90 minutes).
- Compatible with standard mains voltage lighting circuits.
Care:
- Wipe clean with a soft, dry or slightly damp cloth.
- Avoid using abrasive cleaners or solvents.
- Ensure ventilation around the fitting is not obstructed.