Introducing the FloPlast ABS Solvent Weld Female Adaptor 40mm White – a reliable and versatile solution for your plumbing needs. This female adaptor is designed to provide a secure and seamless connection in your plumbing system. Key Features: Size: Tailored for 40mm pipes, the ABS Solvent Weld Female Adaptor ensures a precise fit in your plumbing configuration. Color: The white finish adds a clean and professional look to your plumbing system, complementing various design aesthetics. Solvent Weld Connection: Engineered for secure solvent weld connections, providing a reliable and leak-free joint for your plumbing setup. Versatile Application: Suitable for a variety of plumbing installations, this female adaptor offers flexibility in adapting your plumbing system to different configurations. Benefits: Corrosion Resistance: The ABS material is resistant to corrosion, ensuring a clean and unobstructed water flow through your plumbing system. Aesthetic Appeal: The white finish adds a clean and professional look to your plumbing setup, enhancing the overall aesthetic of your installation. Versatility: The female adaptor's design allows for versatile application, making it suitable for various plumbing configurations and installations. Upgrade your plumbing system with the FloPlast ABS Solvent Weld Female Adaptor 40mm White – a reliable and versatile solution that combines durability with ease of installation, ensuring efficient and secure plumbing connections in your network. A cap and lining, sometimes called a female adaptor, is used to connect waste pipe to a male thread. The threaded cap is a loose section that when tightened, pulls the lining tight up to the opposing threaded pipe or fitting to make the seal. This fitting is available in 32mm and 40mm size options. Our solvent weld waste is manufactured in the UK to BS EN 1455 and is kitemarked. To make a solvent weld joint, first ensure that the outer wall of the pipe and the inner wall of the fitting are both clean and free from grit or swarf. Apply SC250 solvent cement to both surfaces. Push the pipe fully into the fitting and give it a twist to ensure that full contact has been made. Clean off any excess solvent with a damp cloth and leave for 5 minutes to set. The installation should be left for 12 hours before testing. Solvent weld joints are permanent - they cannot be demounted once the joint has been made. When using solvent cement, always work in a well ventilated area and keep the cement away from heat sources or naked flames. Avoid any contact with skin - if contact does occur then wash thoroughly with soap and water.